Epoxy Putty Sticks

Each Epoxy Putty Stick is unique in its own application. Here are general instructions on how to use Epoxy Putty Sticks.  

Before applying, roughen and clean the area to be repaired.

Then follow these easy steps:

·     Cut or twist off required amount.

·     Mix by kneading with fingers to a uniform color. If mixing is difficult, warm the epoxy putty stick to room temperature or slightly above.

·     Apply to surface to be repaired (within two minutes of mixing). Force into any cracks or holes and strike off excess material, preferable with a tool wet with clean water.

 When applying to a damp, wet or slowly leaking area, work the material forcefully into the surface and apply pressure until adhesion begins to take effect.

For best results, use damp fingers for easier mixing and application. Remove excess material before hardening begins. Curing time will vary with individual epoxy putty stick.

Warning

• May cause irritation to sensitive skin. Wash hands with soap and water after use.
• May be harmful if swallowed. • Eye irritant. In case of eye contact, flush with water. Contact physician. • Keep out of reach of children.
• Not intended for use in structural applications.
• When sanding cured putty and substrate, use protective eye wear and dust mask.

Click here to go back to previous page

[What's New] [New Products] [Automotive] [Industrial] [Household] [Downloads] [Links] [About Us] [Contact]